
Storm & Wind Damage Repair in Fort Collins
Fort Collins sits at about 5,000 feet where the Great Plains run into the foothills along the Cache la Poudre River, and that geography drives everything that hits a metal roof here. Spring and summer bring hail that dents panels and strips fasteners, downslope chinook winds peel up ridge caps and edge metal, and heavy wet spring snow loads the seams until water finds a way in. Old Town Victorians, Midtown brick ranches, south Fort Collins two-stories, and foothills cabins up toward Horsetooth and Red Feather Lakes all take the same beating, just in different ways. If you need Storm & Wind Damage Repair in Fort Collins, we inspect the whole roof, document hail and wind damage with photos, and tell you straight whether a repair holds or replacement is the smarter money. We have worked Larimer and Weld county roofs since 2009, and we know what a Cameron Peak smoke-and-ash season does to a finish. Start with a metal roof inspection before you call your insurer.
Why Storm Damage Hits Fort Collins Metal Roofs So Hard
This is not a coastal climate, so the failure modes here are hail bruising, wind-uplift at the edges, and freeze-thaw working on every fastener and flashing joint. Hail crushes the paint film on panels and dents the ribs, and once that coating is compromised, high-altitude sun and snowmelt go to work on the steel underneath. Chinook winds funnel down the foothills and pull at the windward eave, the ridge, and any panel that was not fastened to spec. Heavy wet spring snow sits on the low-slope sections and pushes water past worn gaskets.
- Hail dents the panels and cracks the coating, which opens the door to rust on exposed-fastener roofs.
- Wind lifts ridge caps, edge metal, and loose panels, especially on two-story homes in south Fort Collins and Timnath.
- Freeze-thaw cycles loosen fasteners and open flashing at chimneys and skylights.
- Wet snow loads seams and drives water under the laps on older corrugated and ribbed roofs.
- Ash and debris from foothills wildfire seasons clog valleys and gutters, so water backs up under the panels.
Every one of these shows up as a leak or a lifted fastener before it shows up as a hole, which is why a documented inspection beats waiting for the ceiling to stain.
Key info: After a hail event in Fort Collins, the damage is usually cosmetic on standing seam but structural on exposed-fastener panels. We photograph dents, lifted fasteners, and cracked washers before anyone climbs up to make a judgment call.
Roofing permits and inspection requirements vary by jurisdiction, so confirm the current rules with the City of Fort Collins before any repair or re-roof is scheduled.
How We Handle Storm and Wind Damage Repair Around Fort Collins
We start on the ground with a full look at the roof plane, the edges, and the penetrations, then we get up and check every fastener row, seam, and flashing detail. We photograph what we find, mark the damaged panels or fasteners, and give you a written repair-versus-replace recommendation with the reasoning behind it. Nothing gets ordered or installed until you have seen the photos and agreed on the scope.
- We inspect the roof, gutters, and flashing after the storm and document hail dents, wind uplift, and loose fasteners with photos.
- We check the attic and ceiling for active leaks so we know whether water is already inside the assembly.
- We give you a written assessment of repair versus replacement, with the cost of each path.
- We prepare the insurance documentation package with photos, measurements, and a scope of work you can submit.
- We replace damaged panels, fasteners, ridge caps, and flashing, then water-test the repaired areas before we leave.
If the damage is isolated to fasteners and washers, we handle it as a screw replacement and re-fastening job instead of tearing into good panels.
Key info: A Windsor homeowner called after a July hailstorm with three lifted panels on a ribbed roof and water staining at the ridge. We re-fastened the field, replaced the two crushed panels, reset the ridge cap, and the repair came in under a third of a full replacement quote.
Repair Approaches We Use on Fort Collins Storm Damage
Not every storm-damaged roof needs the same answer. A standing seam roof with a few dented pans is a different job from a 1990s ribbed roof with wallowed screw holes, and we match the approach to the panel type, the age, and how the damage is distributed across the roof.
| Approach | Description | Best for |
|---|---|---|
| Panel and fastener repair | Replace crushed panels and re-fastener loose field screws with new gasketed washers. | Isolated hail or wind damage on exposed-fastener roofs. |
| Edge and ridge re-securing | Reset ridge caps, rake trim, and eave metal that wind has lifted or bent. | Chinook wind damage on two-story homes and foothills properties. |
| Flashing and penetration repair | Rebuild chimney, skylight, and vent flashing where freeze-thaw has opened the seal. | Leaks traced to penetrations after heavy wet snow. |
| Partial re-roof | Replace one slope or section when damage is concentrated and the rest of the roof is sound. | Storm damage limited to one face of the roof. |
| Full replacement | Tear off and install new panels when the damage is widespread or the underlayment is compromised. | Older roofs with damage across multiple slopes. |
We tell you which row your roof falls into, and why, before you commit to anything.
Storm & Wind Damage Repair Cost in Fort Collins: What to Expect
Every storm damage job starts with a free inspection, because the number depends entirely on what we find up there. A handful of replacement screws and washers on a ribbed roof is a small line item. A slope full of crushed panels, lifted ridge cap, and opened flashing is a different conversation. We give you the repair number and the replacement number side by side so you can see the trade-off.
What moves the price: how many panels are damaged, whether the damage is on one slope or across the roof, the pitch and height of the roof, access for ladders and staging, whether the underlayment is wet, and how much flashing and trim has to be rebuilt. Emergency tarping after a storm adds a line, and insurance documentation work takes time that a simple repair does not. Get two or three written estimates and compare scope, not just the bottom line. Our full pricing overview lays out how we structure repair and replacement costs.
Storm & Wind Damage Repair Near Me: How to Vet a Metal Roofing Contractor Near Fort Collins
Storm season brings out-of-state crews who knock on doors after a hail event and disappear before the next one. Ask for the Colorado contractor license, a certificate of insurance for general liability and workers comp, and local references from roofs they did in Fort Collins or Loveland in the last year. Call the references. Ask whether the crew showed up when they said they would and whether the final bill matched the estimate.
Ask who pulls the permit. Repair thresholds and inspection requirements vary by jurisdiction, and in historic districts like Old Town or the Laurel School area, and under HOA design review in Timnath and Windsor, panel profile and color can be restricted. Get the permit question answered in writing before work starts. When you are ready to talk through your roof, reach us through the contact page and we will set up the inspection.
Storm & Wind Damage Repair in Fort Collins: Pricing Guide
| Service | Price | Details |
|---|---|---|
| Storm damage inspection and documentation | Free | Full roof, flashing, and fastener inspection with photos and a written repair versus replace recommendation |
| Fastener and washer replacement | Starting at $450 | Re-fastening loose field screws with new gasketed washers; price moves with roof size and pitch |
| Panel and flashing repair | Starting at $850 | Replacing crushed panels and rebuilding opened flashing; count of damaged panels drives the number |
| Partial re-roof of one slope | On estimate | Needs an on-site look at underlayment condition, access, and how much trim must be rebuilt |
| Travel | Included | In Fort Collins and surrounding Larimer and Weld county areas, no separate call-out or mileage fee |
| Estimate | Free | Response within 24 hours at (970) 545-8912, no obligation to book the work |
Indicative pricing, the exact cost depends on square footage, finish, and site access. Free personalized estimate within 24h at (970) 545-8912.